99800Mah Power Bank Kecemasan Kereta - Pam Tayar + Jump Start, Alat Praktis untuk Kecemasan di Jalan! power bank jumper kereta battery charger 12v 24v Automotive Car battery charger 12v 24v

Printed Capacity : 99800mAh

Output :12V(Car) / 5V-2A(USB)

Input : 15V/1A Max

Shell Material : Plastic

Surface treatment : A light oil

Cycles: 1000+

Starting current : 300A

Peak current : 600A

Size : Approx.17*8.8*3.8cm

Using temperature : -40°C- 80°C Max

Charging time : About 3~5 Hours

Features :

1.Smaller and lighter portable power contrast with the congeneric products.

2.Adopt high capacity high power polymer cells, support fast charging and

low self-discharge, 1000 times charging and discharging cycles.

3.Support 12V car jump start, also power bank for mobile phone, tablet,

PSP, MP3, MP4, GPS, Car CAM, Pocket PC PDA and so on

Package including :

1 x Car Jump Starter

1 x Power Adapter

1 x Car Adaptor

1 x Car Battery Clamps

1 x 3 in 1 USB Cable

1 x Manual Book

1 x Portable Casing

Operation method:

1.Before starting the car, please make sure that the host has at least 2 LED indicators on, then insert the blue plug fully into the host socket, and confirm that the cable indicator is off

2.Connect the red clip to the positive (+) battery terminal and the black clip to the negative (-) battery terminal

3. Start the vehicle

4.After the vehicle is started, remove the clip from the battery.(It is recommended to remove the clip within 30 seconds)

Function description of flashlight:

Highlight lighting: long press the function key

SOS Rescue: Double-click the function key

Flashing prompt: double-click the function key again

Notes:

1.Remove the host within 30 seconds after starting the car.

2.Do not clamp the two terminals on the same end of the battery.

3.Press the switch for five seconds to start.If you want to use LED for lighting, press the switch to change the selected state (light, strobe, SOS, off).

4.During the charging process, slight heating of the device is normal and not a malfunction.

5.Store the product in a cool and dry place, away from direct sunlight.

6.It is normal for the compressor to heat up a bit especially when you pump a flat tyre.Flat one usually takes longer to pump and cause the compressor to heat up a little.

The product cannot be charged:

1.Check whether you are using our charger (15/1A) and whether the charger indicator is on.

2.For models with no count display, when the charger is connected, whether the battery light flashes normally and whether the battery level is rising.

3. If there is an on-board charger, use the on-board charger to charge the car for a while and observe whether the battery level rises. Check whether the problem is with the home charger or the host.

Q: Will your product explode during use, or will the battery swell?

Answer 1: Correct operation will not explode or battery swell.

Answer 2: It is not improper operation. For example, the positive and negative poles of the clamp are connected reversely, the clamp is not fully clamped, the forced start is too large, or the forced start of a large displacement vehicle may cause the battery to burst or swell, but it will not cause spontaneous combustion. Or explode. If you do not understand the instructions, please contact us

Question: Why does the battery clamp burn and melt?

This is because the battery bears a high-intensity load, and the clamp is connected to the battery for too long, which causes the continuous start or forced start of the large-displacement car. There will be no safety issues, but it cannot be used again.

Note: In order for your car to start smoothly, please make sure that the power of the car is above two bars every time you start the car!

USB 2.1A Fast charging

can charge various electronic products

Dual usb interface

DISCLAIMER

Kindly allow a slight difference in actual colour and measuring deviation due to lighting and manual measurement

REFUND AND RETURN POLICY

1. Every product we will be checked and ensure all items are in good condition.

2. Customers need to submit the request within the warranty period stated in the product description. Any late complaint will not be entertained

3. The item must be in an 'as new' condition and returned in the ORIGINAL, undamaged packaging with the accessories

4. Any of these missing, the return request will not be entertained.

5. Any related delivery cost must be bared by buyer

6. The warranty is invalid if:

- Defects and damages are due to misuse, fault of negligence or usage other than the normal and customary manner

- Item is not what customer expected and changing mind

- The product is modified, disassembled, tempered or attempted repair by any person.