2000AMP / 1000AMP Car Battery Jumper Cable Battery Booster Cable Car Jump Cable

1000AMP 2.3 Meter

1. Connect the positive (+) Red Cable to the positive (+) terminal of the dead battery, then carefully connect the other end to the positive (+) terminal of the live battery ,taking care not to ground the clamp whilst doing so.

Connect the negative (-) black cable to the negative (-) terminal of the live battery, then carefully connect the other end to the engine block ,(as far as away from the battery)

Start the car with the live battery and allow it to tick over wait a couple of minutes, and then attempt to start the car with the dead battery.

Note : Do not continuously crank the engine for periods more than 10-15 seconds, if the car does not start almost immediately, wait for one minute and try again, if the car still fails to start, the problem will need to be located and rectified before trying again. Switch off engine of car with live battery and carefully remove the cables in reverse order.

After starting the engine of the car with dead battery, keep both engines running ,carefully remove jumper cable in reverse order r, remove the negative (-) cable from the engine block, then remove the positive (+) cable from the positive terminal the live battery ,then remove the other the order end from the positive (+) terminal of the dead battery

Store jumper cable safely in the handy bag provided.

Cable length: 4 meter

Cable diameter: 9mm

Weight: 1.4kg

Cable length: 2.3 meter

Cable diameter: 8mm