45cm/50cm/60cm/90cm/120cm x 120cm Privacy Window Tinted Tingkap Rumah Cermin Frosted Glass Sticker

 

attention:

- Please purchase enough rolls at a time to ensure that they are from the same batch to avoid color difference.

- The wallpaper you receive may have some wrinkles on the top or both ends, but it will not affect the glue care of the surface.

 

Product name: Thickened frosted self-adhesive glass film

Paste method: oily glue adsorption, no glue needed

Material: High-performance environmentally friendly PET film

UV protection: more than 80%

Uses: decoration, heat insulation, privacy, etc.

Scope of application: any smooth glass surface

 

Specification:

Ordinary pure frosted,

thickened pure frosted

Black window sticker

 

Thickness: about 0.14mm

 

size:

-45cm*120cm (length*width)

 

-50cm*120cm(length*width)

 

-60cm*120cm(length*width)

 

-90cm*120cm(length*width)

 

-60cm*150cm(length*width)

 

-75cm*150cm(length*width)

 

-90cm*150cm(length*width)

 

-60cm*210cm(length*width)

 

75cm*210cm(length*width)

 

90cm*210cm(length*width)

 

 

 

 

 

 

Instructions:

1. Measure the size of the glass. When cutting the film, leave 2 to 3 cm on each side.

2. Clean the glass.

3. Use a watering can or self-made mineral water bottle to make holes, spray more water on the glass, the more the better (to ensure that the film loses its viscosity).

4. Tear one end of the film and fix it on the glass, and then tear off the low paper while sticking it. Spray water on the glued surface of the film to ensure that the film loses its viscosity temporarily.

5. Because there is water, you can adjust the position of the glass film at will and use a scraper to drive the water and bubbles out. If there are no bubbles, only the water is driven out.

6. Use a knife to cut off the extra side that was just left out, and then dry it with a rag to complete it.

 

Notice:

Water spraying is a lubricating effect, which drives out bubbles along the water. If you do not spray water, the film will stick immediately, and there will be bubbles and wrinkles!!

If you stick it directly without spraying water, and then scrape it with a scraper, the film will break!!

The film will stick well when the water dries, so you can spray water with confidence!!