SOLDERED PN532 V3 RFID Card Reader 13.56MHz NFC Module PN 532 V3 Arduino Raspberry Pi STM32 Microbit

- Harga yang tertera adalah harga produk sahaja dan tidak temasuk bantuan / guide teknikal.

- Kami juga menerima tempahan projek Final Year Project, FYP, Projek Tahun Akhir, CODING, PROGRAMMING, RBT, ESP, IOT, Blynk, Telegram, dan lain lain.

- NOTA : Produk dihantar kepada pelanggan dengan kaki male header yang sudah disolder pada board seperti dalam gambar produk.

+ 13.56MHz RFID Card Reader PN532 V3 NFC Module PN 532 V3 Arduino PIC

+ Modul RFID aktif merupakan sebuah modul yang digunakan untuk mengimbas identiti kad atau tag RFID 13.56Mhz melalui frekuensi radio. Modul ini beroperasi menggunakan teknologi tak tersentuh.

+ RFID bermaksud ‘Radio Frequency Identification’.

-------------------------------------

+ PN532

- 80C51 microcontroller core with 40kBROM and 1kBRAM

- Highly integrated analog circuit, demodulation, and decoding response

- Support NFC RFID reading and writing, P2P communication with peers

- Easy to change between communications option

- The output buffer driver is connected to the antenna through a minimum number of external passive devices

- Integrated RF field detector

- Integrated data pattern detector

- Support ISO / IEC14443A / MIFARE®

- Support ISO / IEC14443B only in reader mode

- The typical working distance exceeds 50mm in the reader mode, the specific distance is determined by the antenna size, tuning, and power supply

- Working distance up to 50mm in NFCIP-1 mode, depending on antenna size, tuning, and power supply

- The typical working distance in card operation mode is about 100mm, the specific distance is determined by the antenna size, tuning, and external field strength

- In the reader mode, support MifareClassic encryption which can support two higher data transmission rates of 212kbit / s and 424kbit / s

- In FeliCa mode, support communication baud rate of 106kbit / s, 212kbit / s and 424kbit / s

- Integrated NFCIP-1 RF interface, transmission rate up to 424kbit / s

- Support host interface: SPI interface, I2C interface, Serial UART and Flexible interrupt mode

- Low power consumption mode-hardware power-down mode-software power-down mode

- When the device is in power-down mode, it can automatically wake up through the I2C, HSU, and SPI interfaces

- Programmable timer

- Quartz crystal oscillator