W1209 XH-W1209 Thermostat Temperature / Water Heat Control Sensor Module

•Temperature Control Range: -50 ~ 110 C

•Resolution at -9.9 to 99.9: 0.1 C

•Resolution at all other temperatures: 1 C

•Measurement Accuracy: 0.1 C

•Control Accuracy: 0.1 C

•Refresh Rate: 0.5 Seconds

•Input Power (DC): 12V

•Measuring Inputs: NTC (10K 0.5%)

•Waterproof Sensor: 0.5M

•Output: 1 Channel Relay Output, Capacity: 10A

•Power consumption: static current <=35mA, max current =65mA

•Operating temperature: -10C - 60C

•Operating humidity: 20 - 85%

•Dimension: 48x40x14mm

•The thermostat will display the current temperature in oC by default.

•When in any other mode making no input for approximately 5 seconds will cause the thermostat to return to this default display.

•To set the trigger temperature press the button marked 'SET'. The seven segment display will flash. You can now set a trigger temperature (in oC) using the '+' and '-' buttons in 0.1 degree increments.

•If no buttons are pressed for approximately 2 seconds the trigger temperature will be stored and the display will return back to the current temperature.

•To set any parameter first long press the 'SET' button for at least 5 seconds. The seven segment display should now display 'P0'. This represents parameter P0. Pressing the '+' or '-' buttons will cycle though the various parameters (P0 to P6).

•Pressing the 'SET' button whilst any of the parameters are displayed will allow you to change the value for that parameter using the '+' and '-' buttons (see below).

•When finished setting a parameter press the set button to exit that option. If no buttons are pressed for approximately 5 seconds the thermostat will exit the parameter options and will return back to the default temperature display.

•The parameter P0 has two settings, C and H.

•When set to C (default) the relay will energize when the temperature is reached. Use this setting if connecting to an air-conditioning system.

•When set to H the relay will de-energize when the temperature is reached. Use this setting if controlling a heating device

•This sets how much change in temperature must occur before the relay will change state. For example, if set to the default 2oC and the trigger temperature has been set to 25oC, it will not de-energize until the temperature falls back below 23oC.

•Setting this hysteresis helps stop the thermostat from continually triggering when the temperature drifts around the trip temperature.

•This parameter limits the maximum trigger temperature that can be set. It can be used as a safety to stop an excessively high trigger temperature from accidentally being set by the user.

•This parameter limits the minimum trigger temperature that can be set. It can be used as a safety to stop an excessively low trigger temperature from accidentally being set by the user.

•Should you find there is a difference between the displayed temperature and the actual temperature (for instance if the temperature probe is on a long run of cable) you can make minor corrections to the temperature reading with this parameter

•This parameter allows for delaying switching of the relay when the trigger temperature has been reached. The parameter can be set in one minute increments up to a maximum of 10 minutes.

•Setting a value for this parameter will cause the relay to switch off when the temperature reaches this setting.

•The seven segment display will also show '---' to indicate an alarm condition. The relay will not re-energize until the temperature falls below this value. The default setting is OFF.

•1x XH-W1209 Thermostat Temperature / Water Heat Control Sensor Module

•We are a local seller.

•Estimated delivery lead time: 3-5 working days.

•All items are ready stock in Malaysia

•30 days warranty

•Cash On Delivery is available at Selangor