HEAVY DUTY TUOSEN 7" Inch Circlip Clip Plier Straight Bent Internal External Snap Ring Retaining Muncung Tirus Needle

Instruction to use:#Installing and Removing Internal Snap Rings-Insert the circlip plier tips into the lug holes of the C-clip-Squeeze the handles, bringing the plier tips together; this will reduce the diameter of the retaining ring-Ensure you’re only exerting enough pressure on the retaining ring to insert it into the required position (too much force can damage or break it)-Holding the plier firm and steady, slot the circlip into the groove inside the shaft or bore where it’s going to sit-Release the pliers only when the C-clip is fully seated-To remove an internal retaining ring, simply reverse the order of the steps above#Installing and Removing External Snap Rings-Insert the circlip plier tips into the lug holes of the C-clip-Squeeze the handles, forcing the plier tips apart - this will increase the diameter of the retaining ring-Once again, ensure you’re only exerting enough pressure on the retaining ring to slip it into the required position around the outside of the shaft or dowel (too much force can damage or break it)-Maintain a firm and even grip on the plier handles, and make sure the circlip is fully seated in the groove before releasing - it should click into place when correctly positioned-Release the pliers only when the C-clip is fully seated-To remove an external retaining ring, simply reverse the order of the steps above