【Malaysia Stock】TP4056 18650 5V 1A Lithium battery charging board module Overcharge and overdischarge protection Portable Fast Charging

All products are ready in Selangor, Malaysia

 

TP4056 18650 5V 1A Lithium battery charging board module Overcharge and overdischarge protection type-C/micro USB

 

～The TP4056 is a complete single-cell Li-Ion battery with a constant current/constant voltage linear charger. The SOP40 package with heatsink on the bottom of the TP4056 and fewer external components make the TP4056 ideal for portable applications. The TP4056 is suitable for USB power and adapter power supplies.

～Due to the internal PMOSFET architecture and anti-reverse charging path, no external isolation diodes are required.

～Thermal feedback automatically adjusts the charge current to limit chip temperature during high power operation or high ambient temperature conditions. The charging voltage is fixed at 4.2V, and the charging current can be externally set by a resistor. When the charging current drops to the set value of 1/10 after reaching the final float voltage, the TP4056 will automatically terminate the charging cycle. When the input voltage (AC adapter or USB power) is removed, the TP4056 automatically enters a low current state, reducing the battery leakage current to less than 2uA. The TP4056 can also be placed in shutdown mode when there is a power supply, reducing the supply current to 55uA.

～Other features of the TP4056 include battery temperature sensing, undervoltage lockout, automatic recharge, LED status pins for charging and termination.

 

Charging module basic properties :

1.Charging mode:Linear charging.

2.Current:1A （adjustable）.

Charge precision:1.5%.

Input voltage:4.5V-5.5V.

Full charge voltage:4.2V ± 1%

Led indicator:red is charging Green is full charged.

Input interface:micro USB/type-c usb

Work temperature:-10 to +85.

Inversed polarity:NO.

Packing:1pcs charging board module

 

Protection About Type-c /micro Protection module :

The battery overcharge protection voltage: 4.28 V

Battery overcharge lifting voltage: 4.00 V

The battery discharge protection voltage: 3.0 V

Battery discharge termination voltage: 3.2 V

Battery: over-current protection current 3 A

 

NOTE:

Ampere meter can only be connected to 5v input end of the module.

It is better that the charging current is 37% of the battery capacity. If you charge to the battery of 1000mAH, current of 400 is enough.Too fast charging speed effect is poor, charging finished battery voltage drop more.

The charging connection wire should not be too thin or too long.

Make sure the connect point is good.

If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-substract the charging current to avoid burn damage to chip.

NO Reveral polarity.

 

If you have any questions after receiving the product, please contact us within 48 hours and send a product photo. We will deal with it for you in time.