(5L set) Seamaster Epolux Epoxy Floor Paint Cat Lantai

***Penghantaran Semenanjung Malaysia Sahaja***NOTE: The colours shown here are as close to actual paint colours as modern printing techniques allows. Due to different computer monitors/calibrations colours may vary slightly from the picture.-Seamaster protective coatings are widely used for special areas such as industrial, oil, gas & chemical, marine, infrastructure, storage tanks, concrete floors, bridgesand traffic roads.-Seamaster protective coatings are manufactured with stringent quality control.-This product is especially used in the wood furniture industry. However, it may also be used for metal surfaces.-Gloss : GlossyUSESAs a finish coat of the epoxy system. Suitable for use on steel and cement surfaces where high degree of chemical, oil and abrasion resistance is required.PHYSICAL CHARACTERISTICSIngredient : Polyamide, Epoxy Resin, Inorganic and organic pigments and additivesSolvent : Ketone, ester and  aromatic hydrocarbonMixing Ratio : 4:1 (Based : Hardener) Density : 1.4-1.5 (kg/litre) for mixed paintSolid : Approximately 75%Viscosity : 75 10 KU (mixed paint)  (at 27  0.5˚C)Coverage : 5-7m²/litreGloss : GlossyPot Life  : Approximately 8 hour after mixing (room temperature)PROPERTIESRecommended Film Thickness : 50 - 80 microns per coatDrying Time  : Touch Dry : 2 hours                         Hard Dry : 6 hoursCuring Time  : Normal Service    : 4 days                        Heavy Abrasion Service  : 7 daysRecoating Interval : 2hoursSURFACE PREPARATIONSteel Surface:The mild steel substrate must be completely dry and free from rust, mill scale, dirt, grease an other contaminants before painting. For mazimum adhesion and durability of paint performance all bare metals should be sanded properly.Wood Surface:The woodwork must be dry and free from dirt and other contaminants. Smoothen the surface by sanding and dust off before applying.Aluminium Surface:Remove oils, grease and dirt by using solvent or other cleaning chemicals.Concrete Surface:Remove all previous coating and chalk by lligth abrasive blasting. If abrasive blasting is not available, etch the new and un