Auto Gate Remote Control PT2260 PT2262 KS-92TB 310Mhz 315Mhz 330Mhz 390Mhz 418Mhz 433MHz 8 digits/Face to Face Copy

 

This product cannot use the remote controller with the chip SMC5326-P / SMC5326-S, it is only applicable to the remote controller with the following chip models: 2248A: PT2260, PT2262, PT2264, PT2240, SC2260, SC2262, CS5211, HX2260, HX2262, HS2262, EV1527,HS1527, HS2260, FP527, HX1527, SMC918, AX5026, SMC926 ！

If you are not sure, please check your remote control or consult us before buying! !

8 Digits remote

How to Copy Your Remote Control:

- Open the Original Remote Controller casing

- Refer to the 8 DIGITS adjustable switches

- Open the New Remote Controller casing

- Adjust the 8 DIGITS switches to be exactly the same with the Original Remote Controller

- Now your key is successfully duplicated!

Clone remote

 

Instructions:

1. Clear the code: press the two buttons on the top with two fingers at the same time, the LED light will flash quickly for about 2 seconds, and then release, (how to know whether the code clearing is successful: press one of the remote control buttons, when the LED light is a When it flashes and then goes off, it means that the code is cleared successfully, and the four buttons are empty; if the light is still on after pressing any key on the remote control, it means that the original code has not been cleared successfully. You must clear and successfully clear the code again to successfully clone the code. .You can clean and clone the code repeatedly.)

2. Copy: Use the original remote for the left hand and our cloned remote for the right, and the two remotes are as close as possible. Press the buttons of the remote control at the same time (each button is copied separately), the LED flashes quickly, after about 2 seconds, release your finger. Then press the button, after the learning is successful, the light will be on, indicating that the first key code on the original remote control has been copied to another remote control. The same method can copy the second button, the third button... If the copy is successful, the remote control function is the same as the original paired remote control.

3. Recovery: Note that when you accidentally clear the remote control password, you can press the two buttons at the bottom of the remote control at the same time, and the LED will flash quickly. After releasing, the LED will light up to indicate that the password has been restored.