Product description
- High Quality Construction
- Fully Adjustable Pattern Control
- Maximun Trigger Control
- Non-Bleeder, Siphon Feed
- External-Mix For Fine Atomization
Air Inler : 1/4NPT OR 1/4BSP
Nozzle Size : 1.2mm - 2.5mm
Operating Pressure : 50PSI
Compressor Required : 2-3HP
1. Connect the pressure dye (paint) spray gun.
2. Keep the air pressure within such scope, adjust the pressure until coming to such scope. Different degrees of the finish of the dye in the application environment can have different widths.
3. To spray dye, you must keep the spray gun 15-20cm away from the applied surface. The final layer of spraying can show you the shape of the spray.
4. Always install the valve regulating screws in their proper position (components marked with 18#).
1. Please clean the spray gun with cleansing agent.
2. Always rinse the air valve marked with 1#, the small cap marked with 2# and small plug marked with 3# with a clean brush.
3. Special attention should be paid to the cleaning of the small hole on the small plug and better cleaning is needed for the hole in the middle.
4. Infuse certain amount of solvent into the duct with dye passing through. Do not clean the duct until the solvent softens the paint.
5. After finishing the above cleaning steps, install the duct onto its proper position, tighten the air and dye regulating screws (18#) and then put the spray gun into its proper position.
1 x SPRAY GUN WITH 600CC PLASTIC CONTAINER
1. Due to the light and screen setting difference, the items color may be slightly different from the pictures.
2. Please allow slight dimension difference due to different manual measurement.