BYXGD-6C Fiber cleaver knife FTTH fiber optic tools cutter 16 surface blade CV011

Operation method:

Remove the surface coating with fiber stripper, reserve about 30-40mm, wrap the optical fiber with degreasing cotton dipped in alcohol, and then wipe the optical fiber clean. Put it into the wire slot and cut the optical fiber.

Note that the optical fiber section after cutting should be very careful, do not touch any object, otherwise, the cutting effect will be affected.

Maintenance method:

In case of continuous cutting, the blade can be raised.

If the end of the cut is not flat, you can change a knife point.

Blade service life: