RealyTech Influenza A+B Rapid Test (NASAL)Individual Pack

REALY Tech Flu A/Flu B Ag Rapid Test is for the simultaneous detection and differentiation of the antigens from Covd-2, influenza A and influenza B in the specimens from individuals suspected of respiratory viral infections.

Test Parameters: Covd-2 Ag /Flu A Ag /Flu B Ag

【DIRECTIONS FOR USE】

1. Remove the test device from the sealed foil pouch and use it as soon as possible. Place the

test device on a clean and level surface. The best results will be obtained if the assay is performed

immediately after opening the foil pouch.

2. Take out the Extraction Tube.

3. Take out 1 bottle of Sample Extraction Buffer, remove the bottle cap, and add all the extraction

buffer into the extraction tube.

4. Place the sterilized swab specimen in the sample extraction buffer. Rotate the swab for

approximately 10 seconds while pressing the head against the inside of the tube to release the

antigen in the swab.

5. Remove the sterilized swab while squeezing the sterilized swab head against the inside of

Buffer as you remove it to expel as much liquid as possible from the swab. Discard the sterilized

swab by your biohazard waste disposal protocol.

6. Screw on and tighten the Nozzle with Filter onto the specimen collection tube, then shake the

specimen collection tube vigorously to mix the specimen and the sample extraction buffer.

7. Add 3 drops of the solution (approx.80ul) to each sample well and then start the timer. Read

the result for 10~20 minutes. Don’t interpret the result after 20 minutes.