Smart Home Wireless Touch Switch Light 433MHZ RF Remote Control Relay Glass Screen 1 2 3 gang Wall Panel button led Lamp

Product required 5 days delivery. Do not purchase if urgent. 1. Pass CE,, ROHS certification: 2. Night fluorescent function, multiple combinations (free pairing signal), remote remote control 3.After the power is turned off, turn it on again. Keep closed 4.Highly sensitive design, Drawer box design, Luminous fluorescent strip, Drop resistance design, Large panel, etc. 100M LONG RANGE (in Open area) Wireless switch parameters: Size: 86 * 86 * 10MM Working frequency: 433MHZ Battery: CR2032 battery (excluding battery) Distance: 100M (in open area) Controller parameter Size: 80 * 40 * 25MM Working frequency: 433MHZ Maximum current:: <10A Voltage: AC100 ~ 240V 50 / 60HZ Tip: The obstacle will shorten the distance, the wireless signal is affected by the environment, the more obstacles, the shorter the distance. More Assured And Safer Control multiple lights from multiple places Working principle Input and output intermediate access controller. Wireless switch control current is turned off and on at 433 MHz Luminous fluorescent strip Middle of the night, do not worry about finding the switch Drawer box design Cr2032 Battery , easy to replace the battery The service life is about 12 months. Life and frequency of use are related. Time may be longer (Does not contain battery) Drop resistance design Protective housing,four-corner arc transition, buffer protection HD Tempered Glass Highly sensitive design, can be touched by wet hands Place Anywhere Screw + double-sided adhesive installation Maximum current: 10A / each controller For Example: Voltage = 220V, Power = <2000W; Voltage = 110V, Power = <1100W Controller installation 1.When installing, please turn off the power 2.If the N and L wires of the input terminal are installed oppositely, the lamp will be slightly bright or flickering. 3.If the input and output terminals are installed in opposite directions, the receiver may become unstable or inoperable. Method 1: 1.Press and hold the learning key for 3 seconds until the indicator light stays on (Controller) 2.TOUCH the wireless switch 1 times 3.Indicator light (Controller )flashes twice 4.Pairing signal succeeded note： Entering the learning code mode will last about 10 seconds. If there is no operation, it will automatically exit the learning code mode. Method 2: No need to climb stairs to pair signals 1.touch quickly the (1) wireless switch 4 times 2.touch the (2) wireless switch 6 times 3.Pairing signal succeeded note: 1.Prerequisite: Before operating this step, there must be a pairing signal between the remote control and the controller How to clear the signal 1.Press and hold the learning key for 10 seconds about ，until the indicator light Flashes quickly (Controller) 2.All signals will be cleared